John Lewis SBSKITC Uživatelský manuál

SBSKITCSide by SideInstruction manual

10• Repeat the operation between freezer unit and wine cooler unit.• If necessary adjust the front feet so that the units are both the same height, se

11• Fix the joining bracket (6) with four 4.2x13 self-tapping screws (3) (bag (3) using the holes in the top of thesides, see Fig. (A).• The bracket m

12• If it is necessary to amend the level of the doors (only cooler and freezer units), partially unscrew the hingescrews, related to the door to be a

• Before proceeding with the assembly of the top remove the protective film from the panel (7).• Position the top with the doors open so that the bott

• Fix the top frontaly with three M5X12 screws (1) (bag (1), see Fig. (A).• Fix the back of the top with four 4.2x13 self-tapping screws (3) (bag (3),

15• Fit the trims "11" between the units (freezer/wine cooler - wine cooler/cooler) by pressing along theentire profiles, see figure below.

16• Before proceeding with the fixing of (9,10) side strips remove the protective film.• Insert the side strip, see fig. (A) • Align the outside of t

17• Fit the handles of the three appliances, as shown in figures A, B and C.• The pivots and grub screws are included in the handle-kit.• Screw the tw

18You should also ensure that air can circulate freely around the back and the top of the cabinet.Position the assembled Side by Side:• At least 150 m

19• After the positioning of the appliance, verify the right position with a level.• If necessary regulate the rear feet and front feet to level the a

2Important information• Do not install the unit on your own or have unqualified personnel install it.• Improper installation may result in damage, mal

20• Before proceeding with the fixing of the plinth (8) remove the protective film.• Fit the plinth (8) so that the inner hook couples with the joinin

2221 055-4206/08John Lewis Partnership171 Victoria StreetLondon SW1E 5NNwww.johnlewis.com

3Tools required for installation(not supplied)

4

5

6

7• Carefully place the unit on the floor, following the instructions on the packaging to make sure the unit isfacing upwards.• Open the bottom part of

8• Glue two spacer spongers on the right side of the freezer.• Glue two spacer spongers on both sides of the wine cooler.• Glue two spacer spongers

9• Bring the wine cooler unit near to cooler unit.• If necessary adjust the front feet so that the units are both the same height, see Fig. (A).• Inse